 The Drilling Rig leaving my yard for the last time, on its way to the auction house.
That will let me focus my attention on the pump business.
1 Comment
13/10/2021 07:58:41 pm
With a 1.5 degree bend on the mud motor, I bored a 12-1/4" section and slid 30 stands without back reaming. I circulated the hole clean after finishing my motor run and pulled out of the hole to convert to a rotary BHA. I couldn't pass where I started sliding when I tripped back in the hole, so I had to ream all the way down to the previous TD. It took me an extra 4.5 hours. I adjusted my drilling technique after learning about this incident. I back ream every slide at least once, and I've never had a problem with casing/completion or tripping back in the hole. Leave a Reply. |
by Grant PhillipsI have been running Town & Country Drilling Services since May 2002, coming from a background as a Service Manager in the compressed air industry. I constantly put my Mechanical and Electrical trade experience to good use, assisting customers to find solutions to their pumping requirements. Archives
April 2024
Categories |
RSS Feed
