Water Bore Pump - submersible bore pumps

  • HOME
  • FAQ
  • Water Bore Pump Store
    • Bore Pumps >
      • Fluidtech Australia
      • Grundfos Pumps >
        • Grundfos SP Shop
        • Grundfos SQ Shop
      • PM Technology
      • EXA Pumps Australia
      • Franklin Electric Pumps
    • Solar Water Bore Pumps >
      • FTA-Solar
      • Grundfos Solar Shop
      • Lorentz Solar Shop >
        • Lorentz S1-200 >
          • Lorentz S1-200 page
    • Spearpoint Pumps
    • Minesite and Dewatering
    • Replacement Water Bore Pump Motors
    • Pump Protection and Control Units
    • Accessories
    • Submersible Pump Cables
    • Crusader Hose
    • Clearbore
    • Generators
    • Terms of Trade Warranty
  • Send Bore Information
  • How to
    • Fault Finding Guide
    • Submersible Cable Splice Guide
    • Installation Guide
    • Solar Panel Installation
    • Pressure Switch Adjustment
    • Grundfos PRO-tect AUTO ME set-up
    • Grundfos CU200 wiring
    • Submersible Pump Shroud
  • Dealers
  • Contact Us
  • Pump Maintenance
  • Water Bore Pump Blog
  • HOME
  • FAQ
  • Water Bore Pump Store
    • Bore Pumps >
      • Fluidtech Australia
      • Grundfos Pumps >
        • Grundfos SP Shop
        • Grundfos SQ Shop
      • PM Technology
      • EXA Pumps Australia
      • Franklin Electric Pumps
    • Solar Water Bore Pumps >
      • FTA-Solar
      • Grundfos Solar Shop
      • Lorentz Solar Shop >
        • Lorentz S1-200 >
          • Lorentz S1-200 page
    • Spearpoint Pumps
    • Minesite and Dewatering
    • Replacement Water Bore Pump Motors
    • Pump Protection and Control Units
    • Accessories
    • Submersible Pump Cables
    • Crusader Hose
    • Clearbore
    • Generators
    • Terms of Trade Warranty
  • Send Bore Information
  • How to
    • Fault Finding Guide
    • Submersible Cable Splice Guide
    • Installation Guide
    • Solar Panel Installation
    • Pressure Switch Adjustment
    • Grundfos PRO-tect AUTO ME set-up
    • Grundfos CU200 wiring
    • Submersible Pump Shroud
  • Dealers
  • Contact Us
  • Pump Maintenance
  • Water Bore Pump Blog

Send us information about your water bore

Please use this form to send us information about your water bore.
These details will enable us to select the best pump to suit your requirements.
Picture

    Send Bore Information form

    Region and location. Delivery address. Site address.
    What is the current depth of the water bore, measured from ground level?
    What is the inside diameter of the bore casing? Is the bore casing PVC or steel?
    Standing water level is measured from ground level down to the water level.
    Sometimes the pumping water level is recorded. It is a measurement of the water level below ground level when the pump is running.
    The driller sometimes nominates the depth that the pump should be installed at. In most cases the pump should not be installed at the bottom of the bore. The pump should be installed above the screen.
    What is the maximum yield of the bore. Measured in L/sec, Gallons/hour. m3/hr Litres per minute.
    The pumping volume is always less than the bore yield. The maximum volume may also be restricted by the diameter of the bore casing, available power supply or cost.
    Pumped water from a bore may be used to fill dams, tanks or reservoirs. Pumped direct to irrigation systems or direct into the house.
    Will the pump need automatic controls for tank filling, operate as a pressure system and safety switches?
    Max file size: 20MB
    A picture equals a thousand words.
Submit
Your browser does not support viewing this document. Click here to download the document.
Picture
We Sell Australia Wide
Picture
Contact us:
1300 727 042
​0414 711 131
[email protected]
Warehouse - 5 Coongie Avenue, Edwardstown SA
​PO Box 309 Belair
SA 5052
contact us
photo of
Water Bore Pump Warehouse
[email protected]
Edwardstown , South Australia , 5039 Australia
1300 727 042
This is a website that is proudly owned and operated under Town & Country Drilling Services Pty Ltd.
​All content on this site is protected under copyright law 2014 and is owned by waterborepump.com.au and/or other associated companies.
Town & Country Drilling Services' head office is located at 5 Coongie Avenue, Edwardstown, 5039 South Australia. 
Australian Owned and Operated Company Registered in Australia - ABN:  14 633 265 270
Check out our submersible bore pump BLOG here. 
​Website Design by CorpMentis.com.
Website by Website Manager
Click to set custom HTML