Solar Panel Installation

Solar panel installation guide

  • Dig hole about 1 metre deep for pole. Ensure it is located in a position that will be in full sunlight all day.
  • Align pole to face north.
  • Concrete pole into position.
  • Allow concrete to set.
  • Loosely clamp angle adjustment plates to pole.
Picture










  • fit large main beam.
  • Set to specified angle.
  • Tighten angle adjustment plates.
  • Loosely install steel cross beams.
Picture

  • Loosely fit aluminium rails to cross beams, ensure rails are flush with the top of the angle plates and measure stick out from bottom of cross beams. Set all rails to the same stick out.
  • Measure spacing between parallel cross breams, adjust and tighten all allen screws and bolts.
Picture

  • When the frame is square, parallel and stick out measurements are equal start to fit first two panels.
  • Centre panles onto frame assembly.
Picture

  • Fit remaining panels.
  • Install DC isolator.
  • Ensure DC isolator is in off position.
  • Connect DC leads from panels and connect to isolator.
FREE ADVICE CALL:  1300 727 042
Email: [email protected]

Manufacturers pole mount solar panel installation guide

pv-ezrack_postmount_2-a_installation_guide_v1.0.pdf
File Size: 1510 kb
File Type: pdf
Download File
pv-ezrack_postmount_4-a_installation_guide_v1.0.pdf
File Size: 1434 kb
File Type: pdf
Download File
pv-ezrack_postmount_6-a_installation_guide_v1.0.pdf
File Size: 1601 kb
File Type: pdf
Download File
pv-ezrack_postmount_8-a_installation_guide_v1.0.pdf
File Size: 1610 kb
File Type: pdf
Download File